Godex ez dt4 install#
Godex ez dt4 serial#
Godex ez dt4 driver#

Godex ez dt4 install#

Follow the instruction on Chapter 2-1 to install the label. 【 Note 】 You can also use coin o r screwdriver to open the bottom case cover.ġ0. Unlock the Bottom Case Cover to see the main board of printer.

Loose the screw of Bottom Case Cover and open it. Turn the printer around and tighten screws to fix the Stripper in location. 【 Note2 】 Label liner thickness is recommended to be 0.0 6mm ± 10% with basic weight 65g/ ㎡ ± 6%.ĮZ-DT-4 EZ-DT-2 5. Stripper Module Installation 1 Stripper Module 2 Screw x 2pcs 【 Note1 】 Please power off the printer before installing the stripper module.

Godex ez dt4 driver#

Check if all printer settings are correct and then press Finish to start copying driver files.ģ. A description page of printer settings will be displayed after all settings are completed. Enter the printer name and set printer sharing option. Follow the instruction on screen to keep the installation going.Ħ. Select the icon of driver file and click it to start the installation. Insert product CD to your computer’s CD Drive and find the 'Windows Drives' folder.

Godex ez dt4 serial#

Connect the cable to the USB/ Serial port on the printer and o n the PC.Ģ-4. Take the power cable, plug the cable sw itch to the po wer socket, and then connect the other end of the cable to the printer power so cket.

Please make sure the printer is powered off. When the lock hole of Label Roll Core is on upper side, it applies to 1” core.Ģ-3. Whirl the Label Roll Core back to the original position. Turn the Label Roll Core outward as the figure shows. Pull the Label Roll Holder to the topmost and lift the Label Roll Core upward. Close the Top Cover to complete the label installation.Ģ-2. Pull the Label Guide inward and make it fit the edge of label. Put the label under the Label Guide and stretch it frontward. Place a new label roll onto the Label Roll Core.ħ. Pull up the Label Roll Holder and lift the Label Roll Core upward. Press and release the lock of Label Roll Core. Place the printer on a horizontal surface and open the Top Cover. Communication Interface Serial Interface Serial Default Setting : 9600 baud rate ､ no parity ､ 8 data bits ､ 1 stop bit ､ XON/XOFF protocol and RTS/CTS 。 RS232 HOUSING (9-pin t o 9-pin).ġ-4.  Barcode printer  Power cord  Switching Power  USB Cable  Label  Quick Start Guide  CD (includes label editing software QLabel / Manual) EZ-DT-2 EZ-DT-4 1-2.ĭownload Fonts Bitmap fonts 90°, 180°, 270° rotatable, single ch aracters 90°, 180°, 270° rotatable A sian fonts 90°, 180°, 270° rotatable an d 8 times expandable in horizontal and vertical. Printer Accessories After unpacking, please check the acce ssorie s that come with the p ackage, and store appropriately. Disconnect the equipment from the volta ge of the power source to p revent possible transient over voltage damage.ġ. Before you connect the equipment to the power outlet, please check the voltage of the power source. Safety Instructions Please read the following instruction s seriously. Bevor Sie die Geräte ans Stromnet z ansc hließen, verge wissern Sie Sich, dass die Spannung des Geräts mit der Netzspan nung übereinstimmt. Die Geräte nicht der Feuch tigkeit aussetzen. Safety Instructions Bitte die Sicherheitshinweise sorgfältig lese n und für später aufheben.